×

cisco

Cisco AP1810W clear factory reset

lixiaoyao lixiaoyao 发表于2020-11-24 07:50:38 浏览3073 评论0

抢沙发发表评论

When you have a cisco ap 1810w Lightweight AP want clear the configuration. use follow step


Cisco 1810 瘦ap重置

console 连接设备

登陆用户名 cisco

密码Cisco

enable 密码 Cisco


sh run  //显示当前运行配置文件参数

sh ip interface b   //显示当前网络接口状态及IP地址

sh ver    // 显示当前设备信息及固件版本


AP1810W.5410#capwap ap erase all  // 清除 瘦ap的配置信息,会重启设备
This command will clear ap config and reboot the AP.
AP1810W.5410#[*04/07/2020 08:49:23.9544] /etc/factory_reset.sh config capwap_ap
[*04/07/2020 08:49:23.9644] Config Factory Reset triggered: clear saved config files..


Writing reload timestamp (Tue Apr  7 08:49:24 UTC 2020) to disk


[04/07/2020 08:49:25.1241] UBIFS: un-mount UBI device 0, volume 3
[*04/07/2020 08:49:25.1840]
Sent SIGTERM to all processes!!!! [*04/07/2020 08:49:25.2340]
Sent SIGKILL to all processes
Requesting system reboot37]
[04/07/2020 08:49:27.2334] Restarting system.
[04/07/2020 08:49:27.2734] Going down for restart now


U-Boot 2012.07 (btldr release 38) (Oct 29 2019 - 06:39:45)

This product contains some software licensed under the
"GNU General Public License, version 2" provided with
ABSOLUTELY NO WARRANTY under the terms of
"GNU General Public License, version 2", available here:
http://www.gnu.org/licenses/old-licenses/gpl-2.0.html

DRAM:  512 MiB
NAND (ONFI): Detected SPANSION S34MS02G2 [256 MiB]
SF: Detected Macronix MX25U3235F [4 MiB]
MFG data loaded
Scanning shenv data blocks
Total valid parts=4
Active shenv part[1:0], write_counter=15
PCI0 Link Intialized
PCI1 Link Intialized
Net:   
Dev ID = 0x1302, QCA8337 Detected...
athrs17_reg_init: complete
athrs17_vlan_config ...done
MAC1 addr:0:a2:89:12:54:11
MAC2 addr:0:3:7f:ba:db:2
Valid I2C chip addresses: 51 52
AP 1810 detected...
Power Type: 802.3af POE or Others detected...
Signature returns 0
BL signing verification success, continue to run...
Auto boot mode, use bootipq directly
Hit ESC key to stop autoboot:  0
Specified BOOT: part1

Booting from part1

Read 1024 bytes from volume part1 to 45000000
Read 25993685 bytes from volume part1 to 45000000
UBI: fixable bit-flip detected at PEB 673
UBI: schedule PEB 673 for scrubbing
UBI: fixable bit-flip detected at PEB 673
Signature returns 0
Image signing verification success, continue to run...
Using machid 0x1260 from environment

Starting image ...

[01/01/1970 00:00:00.0000] CPU: ARMv7 Processor [512f04d0] revision 0 (ARMv7), cr=10c5387d
[01/01/1970 00:00:00.0000] CPU: PIPT / VIPT nonaliasing data cache, PIPT instruction cache
[01/01/1970 00:00:00.0000] Machine: Cisco Systems 11ac Wave2 Wifi Access Point
[01/01/1970 00:00:00.0000] Memory policy: ECC disabled, Data cache writealloc
[01/01/1970 00:00:00.0000] Kernel command line: ubi.mtd=0 crashkernel=500M-:64M@1280M console=ttyHSL1,9600n8 activepart=part1 activeboot=0 wdgtriggered=0
[01/01/1970 00:00:00.1500] CPU1: Booted secondary processor
[01/01/1970 00:00:00.2100] Initializing GSBI6 UART clocks...Done.!
[01/01/1970 00:00:00.2200]
[01/01/1970 00:00:00.2200] +++ hydra_ap_gpio_value =1
[01/01/1970 00:00:17.2647] ACPU PVS: 2
[01/01/1970 00:00:19.4341] buginf tty flushing thread started, ttyport=de063690
[*01/01/1970 00:00:25.4922] buginf() enabled.
[*01/01/1970 00:00:25.5022] Made it into bootsh: Feb 17 2020 12:31:08
[*01/01/1970 00:00:25.5022] bootsh build T-eaf8c9a5819ff90fa88df9b4045e20adf0d0a259-geaf8c9a5-vipendya

Welcome to Cisco.

Usage of this device is governed by Cisco's End User License Agreement,
available at:
http://www.cisco.com/c/en/us/td/docs/general/warranty/English/EU1KEN_.html.

。。。


*04/07/2020 08:50:10.6155] dtls_init: Use MIC certificate
[*04/07/2020 08:50:10.6155]
[*04/07/2020 08:50:10.6155] CAPWAP State: Init
[*04/07/2020 08:50:10.6155]
[*04/07/2020 08:50:10.6155] Config not found, PNP is required, Starting PNP
[*04/07/2020 08:50:10.6155]
[*04/07/2020 08:50:10.9854] ip6_port srcr6, ip6local fe80::2a , ip6 ::, plen 0, gw6 fe80::210:18f  gw6_mac 00 , mtu 1500, vid 0, mode6 3(slaac)
[*04/07/2020 08:50:16.2537] ip6_port srcr6, ip6local fe80::2a2 , ip6 240e:388:5bfd:4400:2a2:89ff:fe12:5410, plen 64, gw6 fe80::210:1 , gw6_mac 00: , mtu 1500, vid 0, mode6 3(slaac)
[*04/07/2020 08:50:18.3631] PNP:Server not reachable, Start CAPWAP Discovery
[*04/07/2020 08:50:18.3631]
[*04/07/2020 08:50:18.3631] CAPWAP State: Discovery
[*04/07/2020 08:50:18.3631] IP DNS query for CISCO-CAPWAP-CONTROLLER.lan
[*04/07/2020 08:50:18.3830] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*04/07/2020 08:50:18.3930] Discovery Request sent to ff02::18c, discovery type UNKNOWN(0)
[*04/07/2020 08:50:18.3930]
[*04/07/2020 08:50:18.3930] CAPWAP State: Discovery
[*04/07/2020 08:50:27.8701]
[*04/07/2020 08:50:27.8701] CAPWAP State: Discovery
[*04/07/2020 08:50:27.8701] IP DNS query for CISCO-CAPWAP-CONTROLLER.lan
[*04/07/2020 08:50:27.8801] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*04/07/2020 08:50:27.8901] Discovery Request sent to ff02::18c, discovery type UNKNOWN(0)
[*04/07/2020 08:50:37.3771]
[*04/07/2020 08:50:37.3771] CAPWAP State: Discovery
[*04/07/2020 08:50:37.3771] IP DNS query for CISCO-CAPWAP-CONTROLLER.lan
[*04/07/2020 08:50:37.3871] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*04/07/2020 08:50:37.3871] Discovery Request sent to ff02::18c, discovery type UNKNOWN(0)
[*04/07/2020 08:50:46.8841]
[*04/07/2020 08:50:46.8841] CAPWAP State: Discovery
[*04/07/2020 08:50:46.8841] IP DNS query for CISCO-CAPWAP-CONTROLLER.lan
[*04/07/2020 08:50:46.8941] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*04/07/2020 08:50:46.8941] Discovery Request sent to ff02::18c, discovery type UNKNOWN(0)
[*04/07/2020 08:50:56.4012]
[*04/07/2020 08:50:56.4012] CAPWAP State: Discovery
[*04/07/2020 08:50:56.4012] IP DNS query for CISCO-CAPWAP-CONTROLLER.lan
[*04/07/2020 08:50:56.4112] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*04/07/2020 08:50:56.4112] Discovery Request sent to ff02::18c, discovery type UNKNOWN(0)
[*04/07/2020 08:52:01.2309] PNP:Server not reachable, Start CAPWAP Discovery
[*04/07/2020 08:52:01.2309]
[*04/07/2020 08:52:01.2309] Lost connection to the controller, going to restart CAPWAP (reason : Post startCapwapDiscovery)...
[*04/07/2020 08:52:01.2309]
[*04/07/2020 08:52:01.2309] Restarting CAPWAP State Machine.
[*04/07/2020 08:52:01.3409] Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Discovery(2).
[*04/07/2020 08:52:01.3609]
[*04/07/2020 08:52:01.3609] CAPWAP State: DTLS Teardown
[*04/07/2020 08:52:06.0494]
[*04/07/2020 08:52:06.0494] CAPWAP State: Discovery
[*04/07/2020 08:52:06.0494] IP DNS query for CISCO-CAPWAP-CONTROLLER.lan
[*04/07/2020 08:52:06.0694] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*04/07/2020 08:52:06.0794] Discovery Request sent to ff02::18c, discovery type UNKNOWN(0)

AP00A2.89 #sh running-config //显示当前运行配置
AP Name                    : AP00A2.8
Admin State                : Enabled
AP Mode                    : Local
AP Submode                 : None
Location                   : default location
Reboot Reason              :
Primary controller name    :
Primary controller IP      :
Secondary controller name  :
Secondary controller IP    :
Tertiary controller name   :
Tertiary controller IP     :
AP join priority           : 1
IP Prefer-mode             : Unconfigured
CAPWAP UDP-Lite            : Unconfigured
Last Joined Controller name:
DTLS Encryption State      : Disabled
Discovery Timer            : 10
Heartbeat Timer            : 30
CDP State                  : Enabled
Watchdog monitoring        : Enabled
IOX                        : Disabled
RRM State                  : Enabled
LSC State                  : Disabled
SSH State                  : Disabled
AP Username                : Cisco
Session Timeout            : 300
Extlog Host                : 255.255.255.255
Extlog Flags               : 0
Extlog Status Interval     : 0
Syslog Host                : 255.255.255.255
Syslog Facility            : 0
Syslog Level               : errors
Core Dump TFTP IP Addr     :
Core Dump File Compression : Disabled
Core Dump Filename         :
Client Trace Status        : Enabled(All)
Client Trace All Clients   : Enabled
Client Trace Filter        : 0x0000000E
Client Trace Out ConsoleLog: Disabled
WLC Link LAG status        : Disabled
AP Link LAG status         : Disabled
AP WSA Mode                : Disabled



已经清除配置了。

访客