请问一下，我按照你的方法生成了基于Linux5.4.109的patch包，最后要...
1月1日最新源码编译的openwrt x86固件无法驱动绿联2.5G usb网卡(rtl8156)和比亚兹2.5G usb网卡(8156b)，具体表现为lsusb可以看到设备，但是没有生成eth设备。Bus 001 Device 002: ...
还有 1 人发表了评论 加入8712人围观计算机硬件
Garmin gps 切换USB MTP模式
lixiaoyao 发表于2017-09-30 浏览2752 评论0
Some automotive devices use Media Transfer Protocol (MTP) for connecting to your computer. MTP provides a more secure environment for the important system files on your device.
MTP connectivity requires the following.
Windows XP with service pack 3 or later.
Windows Media Player 11 or later.
计算机硬件
garmin gps 进入 debug 模式
lixiaoyao 发表于2017-09-30 浏览2645 评论0
The "debug menu" (also called the "maintenance mode") on a Garmin Nuvi 750 is a utility that allows you to reset your device back to factory settings.
You can reset any addresses saved to the device as well as custom points of interest, such as restaurants, hotels or whatever.
You don't need to do anything special to enter this menu on the device, you simply just need to press in the right location at the right time.
Steps to Enter Debug Menu
1.Turn off your Garmin Nuvi 750.
2.Press and hold your finger in the lower, right-hand corner of the Nuvi 750's touchscreen.
3.Turn on your Nuvi 750 while continuing to press on the unit's screen. This will launch the debug menu on the device.
4.Press "Yes" or "No" when asked if you want to restore your device factory settings. You can also press the other button on-screen to continue into "maintenance" or "debug" mode.
Exit the Debug Menu
To exit out this special menu on your Garmin Nuvi 750, simply turn the device off and turn it back on again.
Garmin 3597
进入调试模式 ， 长按右上角 电池位置5秒